Nbg-416N Access And Login - ZyXEL Communications NBG-416N User Manual

Chapter 20 Troubleshooting
Inspect your cables for damage. Contact the vendor to replace any damaged
3
cables.
Disconnect and re-connect the power adaptor to the NBG-416N.
4
If the problem continues, contact the vendor.
5

20.2 NBG-416N Access and Login

I don't know the IP address of my NBG-416N.
The default IP address in router mode is 192.168.1.1 and in non-router mode is
1
192.168.1.2.
If you changed the IP address and have forgotten it, you might get the IP address
2
of the NBG-416N by looking up the IP address of the default gateway for your
computer. To do this in most Windows computers, click Start > Run, enter cmd,
and then enter ipconfig. The IP address of the Default Gateway might be the IP
address of the NBG-416N (it depends on the network), so enter this IP address in
your Internet browser.Set your device to Router Mode, login (see the Quick Start
Guide for instructions) and go to the Device Information table in the Status
screen. Your NBG-416N's IP address is available in the Device Information
table.
• If the DHCP setting under LAN information is None, your device has a fixed
IP address.
• If the DHCP setting under LAN information is Client, then your device
receives an IP address from a DHCP server on the network.
If your NBG-416N is a DHCP client, you can find your IP address from the DHCP
3
server. This information is only available from the DHCP server which allocates IP
addresses on your network. Find this information directly from the DHCP server or
contact your system administrator for more information.
Reset your NBG-416N to change all settings back to their default. This means your
4
current settings are lost. See
for information on resetting your NBG-416N.
I forgot the username and password.
156
Section 20.4 on page 159 in the Troubleshooting
NBG-416N User's Guide