Wireless Problems - ZyXEL Communications NBG-416N User Manual

Chapter 20 Troubleshooting
If the NBG-416N restarts automatically, wait for the NBG-416N to finish
restarting, and log in to the Web Configurator. The username is admin and
password is 1234.
If the NBG-416N does not restart automatically, disconnect and reconnect the
NBG-416N's power. Then, follow the directions above again.

20.5 Wireless Problems

I cannot access the NBG-416N or ping any computer from the WLAN.
Make sure the wireless LAN is enabled on the NBG-416N.
1
Make sure the wireless adapter on the wireless station is working properly.
2
Make sure the wireless adapter installed on your computer is IEEE 802.11
3
compatible and supports the same wireless standard as the NBG-416N.
Make sure your computer (with a wireless adapter installed) is within the
4
transmission range of the NBG-416N.
Check that both the NBG-416N and your wireless station are using the same
5
wireless and wireless security settings.
Make sure traffic between the WLAN and the LAN is not blocked by the firewall on
6
the NBG-416N.
Make sure you allow the NBG-416N to be remotely accessed through the WLAN
7
interface. Check your remote management settings.
• See Chapter 6 Wireless LAN
I cannot access the Web Configurator after I switched to a non-router mode.
When you change from router mode to a non-router mode, you must manually
give your computer an IP address in the range between 192.168.1.3 and
192.168.1.254 as non-router mode has no LAN DHCP server.
Refer to
computer's IP address.
160
Appendix B on page 171
for more information.
for instructions on how to change your
NBG-416N User's Guide