Gateway Server E-9520T User Manual page 58

CHAPTER 4: Installing Components
52
Remove the backplane and place it in a static-free bag for storage.
10
Holding the new backplane by the edges only, align it with the locking
11
tabs on the hard drive cage, then place it on the locking tabs and slide it
up.
Tighten the thumbscrew to secure the backplane to the hard drive cage.
12
Slide the hard drive cage back into the opening in the front of the chassis
13
until it clicks into place.
Reconnect all cables to the backplane.
14
Connect to Mezzanine Board
Replace the system fans by following the instructions in
15
fans" on page 43.
Set the chassis upright, if necessary.
16
Follow the instructions in
17
Reinstall the hot-swap drives back into the server. Make sure that you
18
install the drives into the same bays you removed them from in
instructions see "Removing and installing a hard drive" on page
Replace the bezel by snapping it into place on the front of the server.
19
"Closing the server case" on page
www.gateway.com
"Replacing system
30.
Step 4. For
33.