Gateway Server E-9520T User Manual page 56

CHAPTER 4: Installing Components
Important
Make sure that the power supply cable
box is connected to the power supply
connector(s) on the power supply(ies).
50
Disconnect the main power, CPU power, backplane power, I
5
midplane power cables. See
the connectors on the system board.
Loosen the thumbscrew (1) holding the power distribution board in place,
6
then slide the power distribution board (2) away from the side of the
chassis to release it.
Lift the power distribution board (3) out of the chassis.
7
Align the new power distribution board with the power supply cage and
8
the standoffs, then push it down onto the standoffs.
Slide the power distribution board toward the side of the chassis, then
9
tighten the thumbscrew to secure it to the chassis.
Reconnect the power cables. See
10
location of the connectors on the system board.
Set the case upright, if required.
11
Reinstall the power supply modules by following the instructions in
12
"Replacing a power supply module and power board" on page
Follow the instructions in
13
"System board" on page 5
"System board" on page 5
"Closing the server case" on page
www.gateway.com
2
C power, and
for the location of
for the
48.
30.