Gateway Server E-9520T User Manual page 48

CHAPTER 4: Installing Components
Do not touch the contacts on the bottom
part of the expansion card. Touching the
contacts can cause electrostatic damage
Make sure that you only plug a PCI-X
expansion card into the PCI-X slot.
Plugging a PCI-X expansion card into a
PCI slot may damage the PCI-X card.
42
Press down on the top of the expansion card latch (3) for the PCI expansion
Caution 4
card you are removing, then rotate the latch up (4) to release the card.
to the card.
Gently remove the PCI card from the card slot, then lift the PCI card out
5
of the chassis.
Position the new PCI expansion card over the PCI slot, then press the PCI
Caution 6
expansion card into the PCI slot.
From the back of the server, push the expansion card latch in to the locked
7
position.
If you opened the card guide initially, rotate the card guide tab down to
8
the locked position.
Follow the instructions in
9
See the card's documentation for software installation instructions.
10
"Closing the server case" on page
www.gateway.com
30.