In The Fuser Unit - Oki C9300dn User Manual

IN THE FUSER UNIT

If there is any paper jammed in the fuser unit, carry out the following:
The fuser unit is very hot after printing. Always use the handle when
lifting it.
Move the two coloured locking levers either side of the
(a)
fuser unit toward the rear of the machine (they are
spring loaded toward the front).
Remove the fuser unit, holding the unit by the handle,
(b)
and place it on a flat table.
With the coloured lever on the fuser unit to your left,
(c)
move it in the direction shown. Slowly remove any
jammed paper.
Replace the fuser unit into the printer.
(d)
Ensure that the fuser unit locks into place.
(e)
WARNING!
TROUBLESHOOTING > 164