Table of Contents
Advertisement
Insert the memory modules into one of the three SDRAM slots
3.
as follows:
The printer may not operate correctly if memory modules are not
fitted correctly and IN THE CORRECT SEQUENCE.
If the memory modules are of the same capacity, the
(a)
order of SDRAM slots to use is Slot 1, Slot 3, and Slot 2.
If the memory modules are of different part number/
(b)
capacity, insert the highest module into Slot 1, the
second highest into Slot 3 and the lowest into Slot 2.
Replace the mother board and secure it with the two
(c)
screws.
Reconnect the printer interface cable and power cable, then
4.
switch on the printer.
If the error message SERVICE CALL/034 appears on the LCD after
switching the printer on, make sure the memory modules have been
installed correctly.
CAUTION!
NOTE
ACCESSORIES > 179
Advertisement
Table of Contents
