Positioning/Aligning Dvb-T Antenna - Loewe Xelos 32 LED Operating Instructions Manual

Initial installation
Time and date
INITIAL INSTALLATION
Time and date
Time
Date
Proceed
OK
Select time / date.
If no values or no correct values have been entered
for the data and time, enter the correct values with
the numeric buttons here.
OK Proceed.
Sound playback
SOUND COMPONENTS
via ...
Sound playback via ...
TV speakers
Speaker system
HiFi/AV amplifier or TV speakers (switchable)
End of wizard
OK
Select sound components.
This selection indicates which sound components
you want to use to hear your TV sound. Depending
on the selection, the sound component wizard starts
with which you can make further settings.
The sound component wizard is described from page
96 and can also be started at any time outside of
first time operation (TV menu under Connections
Sound components).
OK End of wizard.
- 28
09:19:14
0 - 9
26.02.2010
Back
OK

Positioning/aligning DVB-T antenna

If you are receiving one or more DVB-T stations with picture and sound
interference then you should change the installation location and align-
ment of the antenna. Ask your dealer to tell you which channels are used
to broadcast the DVB-T stations in your region.
➠ In normal TV mode, without other displays.
A DVB-T station is received and selected.
MENU: Call TV menu.
Select Settings,
go to the menu line below.
Select Stations,
go to the menu line below.
Select Manual adjustment,
OK call manual adjustment.
SIGNAL SOURCE
Select the area in which you want the broadcaster to search here. You can use
the button to automatically select station by station.
MANUAL ADJUSTMENT
Signal source
Channel
Frequency
Bandwidth
Name
C/N
Level
BER
The signal source is already on DVB-T due to the station
preselection.
Position and align the antenna in such a manner that
maximum values for C/N and Level are obtained.
Blue button: Start search.
Search for DVB-T stations one after another and compare
values for C/N and Level.
Then position/align the antenna to the weakest station
so that maximum values for C/N and Level are obtained.
The value for BER should be as low as possible.
Thereafter perform an automatic search for all DVB-T
stations (see page 39).
DVB-T DVB-C DVB-S
E05
177.50 MHz
7 MHz
81
80
0 E-7
Store
Search
Ca