Loewe Xelos 32 LED Operating Instructions Manual page 22

Initial installation
Selecting The selection options for the aerials depend on the
antennas
receiver units installed or upgraded at the factory (see
(continued)
also page 115).
Depending on which antenna(s) was (were) selected, the
appropriate settings are called later during the routine.
OK proceed.
Subtitle and
INITIAL INSTALLATION
Subtitle and audio languages (DVB)
audio
Favoured subtitle language
languages
Alternative subtitle language
Favoured audio language
(DVB)
Alternative audio language
Audio commentary
Proceed
OK
Select desired languages and alternative
languages for subtitles and audio for DVB
programmes (see page 53).
Set up audio commentary for the visually
impaired (see page 38).
OK Proceed.
Logical
INITIAL INSTALLATION
Channel
Logical Channel Number
Number Accept Logical Channel Number
Proceed
OK
Accept Logical Channel Number no / yes.
In various countries, digital stations (DVB-T, DVB-C,
DVB-S) are transmitted with a preset channel
number per station, known as "Logical Channel
Numbers" – "LCN".
If you indicate yes here, the specified programme
numbers will be adopted as station memory loca-
tions and the stations of the preferred signal
sources sorted by LCN. There may be gaps in the
numbering of the station list depending on the LCN.
OK Proceed.
Depending on which antennas (DVB-T, DVB-C, DVB-S)
were selected, the appropriate settings appear
below.
- 22
Setting options for DVB-T reception:
English ...
OK
German
English
German
off
Back
no yes
OK
Back
Supply voltage
If you have not selected a DVB-T antenna in the antenna
selection: Continue with setting options for DVB-C recep-
tion on page 23.
Settings
INITIAL INSTALLATION (DVB-T)
Scrambled stations
Search method
Proceed
OK
Select and adapt settings for DVB-T reception.
Encrypted You can state whether coded stations are to be searched
stations for in the search/update.
scrambled stations. However, these stations can only
be received in connection with a CA module and the
appropriate Smart Card.
described on page 55.
If a CA module with a SmartCard is already plugged in for
the station search, all the stations which this module can
descramble are also saved when no is preset.
Search If you want to run the station search independently of
method
the channel grid, select frequency search for the search
method.
OK Proceed.
INITIAL INSTALLATION (DVB-T)
Antenna
Supply voltage
no (0V)
Proceed
OK
Select supply voltage no / yes.
Use a DVB-T antenna that requires a supply voltage
(active antenna) and which is not already supplied
via a power adapter, then select yes (5V) for the
antenna's power supply.
How to align your DVB-T antenna is described on
page 28.
OK Proceed.
no yes
Channel search
Select yes to save all found
Handling of the CA module is
yes (5V)
OK
Back