Appendix; Specifications; Calibrating The Touchscreen - Garmin GPSMAP 700 Owner's Manual

Appendix

Specifications

Physical Specifications
Specification Measurement
Size W × H × D: 8
Weight 2.48 lb. (1.125 kg)
Display W × H: 6 × 3.6 in. (152 × 91 mm)
Case Fully Gasketed, high-impact plastic and aluminum alloy, waterproof to IEC 60529 IPX-7
Temp. Range From 5°F to 131°F (from -15°C to 55°C)
Compass Safe 32.0 in. (813 mm)
Distance
GPS Performance
Specification Parameter
Receiver
Acquisition Warm
Time
Cold
Reacquisition < 1 sec.
Update Rate
Accuracy GPS
DGPS
Velocity
Power
Specification
Source
Usage
Fuse
NMEA 2000 Load Equivalency Number (LEN) 2
NMEA 2000 Draw

Calibrating the Touchscreen

The GPSMAP 700 series chartplotter touchscreen does not normally require calibration. However, if
the buttons do not seem to be responding properly, use the following process to calibrate the screen.
1. While the chartplotter is turned off, press the
The Warning screen appears.
2. Touch anywhere on the black portion of the screen for approximately 15 seconds until the
calibration screen appears.
3. Follow the instructions on the screen until "Calibration is complete" appears.
4. Touch OK.
0
Appendix
/ × 5 / × 3 / in. (226 × 142 × 80 mm)
29 19 1
32 32 8
Measurement
High-sensitivity 12 parallel channel, WAAS-capable receiver
Approximately 1 sec. (The device is at or near the last location at which you
recently acquired satellites.)
Approximately 38 sec. (The device has moved more than about 500 mi.
[800 km] since it was turned off.)
1/sec., continuous
<33 ft. (10 m) 95% typical
10-16 ft. (3-5 m) 95% typical (WAAS/EGNOS accuracy)
0.05 m/sec. steady state
Measurement
10–32 Vdc
8.56 W max. at 13.8 VDC
3 A
100 mA maximum
Power
key.
GPSMAP 700 Series Owner's Manual
®