Error Codes - Duerkopp Adler 550-867 Service Instructions Manual

4.9

Error codes

EC10000
EC20000
EC21000
EC21500
motor
EC21600
from
EC22000
EC22500
EC22600
EC23000
EC23500
EC23600
EC25000
EC25500
EC25600
EC25700
EC25800
EC26000
(additional
EC27000
EC27500
device
EC28000
EC29000
EC31010
EC31000
with
EC31500
EC32000
EC33000
ECxxxxxACK
"xxxxx"
ECxxxxxCNT
processing
Acknowledging an error through the supervisor
Check the thread tension, currently not in use
Forced thread trimming in a tearing seam
Received a wrong error message from the Efka
Received a wrong bobbin thread message
the Efka motor
Forced bartack in a tearing seam
Wrong bartack in the seam
Wrong stitch counting motor and PC
Thread breakage in a tearing seam
Thread tension too low in a tearing seam
Thread tension too high in a tearing seam
Thread breakage within a free seam
Thread tension too low in a free seam
Thread tension too high in a free seam
Edge detection upper limit overran
Edge detection lower limit overran
Did not read the extra bar code label
bar code)
Hardware-error, Efka control unit does not
react properly
Hardware-error, Thread tension measuring
does not react properly
Remained below the allowed stitch area
Exceeded the allowed stitch area
Incorrect reading of the final label bar code
Incorrect reading of the final label bar code
the manual scanner of the supervisor
Wrong final label sewn into the workpiece
A bobbin with a non approved thread has been
inserted during the sewing process
Bar code printer not ready
The supervisor has acknowledged the error
The supervisor has released the further
of the workpiece despite the error "xxxxx"
91