2.13 Potentiometer in the arm
1
2.13.1
Basic setting without control panel
(3)
(2)
Sewing machines with thread trimmer are equipped with a
potentiometer in order to limit the sewing speed of higher sewing foot
strokes. Through this potentiometer the control unit recognizes the
sewing foot stroke and limits the sewing speed.
2
Set sewing machines without control panel according to the following
description.
Caution: Risk of injury!
Turn off the main switch.
Set the potentiometer only with the sewing machine switched off.
–
Pull out the plug 3 of the potentiometer on the PCB 4.
–
Check the resistance on the terminals (2) and (3) of the
potentiometer with an ohmmeter. Terminal (3) = green wire
Terminal (2) = brown wire Measuring value: 7.1 to 7.3 kOhm
If the values mentioned are not correct, the position of the
potentiometer 2 has to be adjusted.
–
Loosen screw 1.
–
Set the shaft of the potentiometer 2 to the corresponding value.
–
Push the potentiometer completely into the bore hole of the
setting shaft and tighten screw 1.
–
Plug in plug 3 of the potentiometer on the PCB 4.
4
3
43