Graduation On The Handwheel - Duerkopp Adler 550-867 Service Instructions Manual

1.3

Graduation on the handwheel

3
The handwheel 2 has a graduation printed on it.
Certain settings are carried out according to the position of the
handwheel.
–
Turn the handwheel until the degree mark mentioned in the
present instructions points to the index 3.
–
Carry out the described adjustment.
Setting the handwheel
–
Set the handwheel to the degree mark 50°
–
Loosen the threaded pin for the handwheel through opening 1.
–
Set the handwheel to 0°
–
Arrest the machine in position II with the locking pin Ø 3 mm
–
Loosen the threaded pin for the handwheel through opening 1.
–
Turn the handwheel 2 so that the degree mark 0° points to the
middle of the index 3.
–
Tighten the threaded pin for the handwheel through opening 1.
–
Set the handwheel to 50° and tighten the threaded pin for the
handwheel.
1
2
5