Table of Contents
Advertisement
10.
Error messages
10.1 Pressure monitor
10.2 Firm hold
10.3 Error messages
10.4 Needle not in starting position
10.5 Handwheel turned manually
10.6 Sewing-start not correct
34
The pressure monitor monitors the pressure of the air supply. If the
pressure is inadequate this warning message appears in the display.
Fault rectification
–
Switch the machine off.
–
Ensure that the air pressure is adequate.
–
Switch the machine on again.
When the machine is in firm hold mode this warning message appears
in the display.
If an error or fault occurs, a window containing an error code appears.
Error messages are described in the Servicing instructions.
If the needle is not in its upper starting position when sewing begins,
appears this message appears.
Rectification
–
Turn the handwheel until the message disappears.
If the machine is halted during operation and the handwheel turned,
this symbol appears when it is restarted.
The current sewing process must be abandoned.
If when sewing begins the needle is about to execute the right needle
insertion on subclasse 221 (or the left needle insertion on subclass
212), this warning message appears.
To clear the error turn the handwheel until the message disappears.
If the warning message appears straight after switch-on, the RST key
must be pressed when the message has disappeared.
The machine moves to the starting position.
Advertisement
Table of Contents
