Printer Calibration - Duerkopp Adler 550-867 Service Instructions Manual

4.13.3

Printer calibration

110
Note!
Both printer drivers have to be installed in order for the printer to work
properly and so that the operating system will not find a new hardware
at each start-up.
Rename the printer driver installed by the operating system for a
better identification.
–
Select the driver "Zebra GK420T (Copy1)".
–
Right-click with the mouse.
–
Click "rename".
–
Rename the driver to Zebra GK420t (ZPL).
With its built-in light barrier the label printer sets itself automatically to
the correct distance between the labels on the support material.
If the correct distance is not recognized automatically the printer has
to be recalibrated.
For further information, please consult the page 82 of the operating
instructions of the manufacturer.