Feeding Foot And Presser Foot; Feeding Foot And Presser Foot Stroke - Duerkopp Adler 550-867 Service Instructions Manual

2.8

Feeding foot and presser foot

2.8.1

Feeding foot and presser foot stroke

2
26
1
Caution: Risk of injury!
Turn off the main switch.
Check and set the stroke of the sewing feet only when the machine is
switched off.
Standard checking
Setting of the cylinder
With the multi-position cylinder lifted the tongues 4 of the stitch
regulator gear have to be flush.
When actuating the multi—position cylinder and when turning the
handwheel the stroke of the sewing feet 1 and 2 should be identical.
Correction
–
Remove the arm cover.
–
Turn the handwheel to position 0°.
–
Loosen screw 3.
–
Push the feeding foot 2 completely onto the throat plate.
–
Tighten screw 3.
–
Put the arm cover back on again.
–
Actuate the cylinder.
–
Check whether the two strokes are identical now. If not readjust
the setting.
4 3