Error Messages; Firm Hold; Needle Not In Starting Position; Handwheel Turned Manually - Duerkopp Adler 579 Operating Instructions Manual

10.

Error messages

10.1 Pressure monitor

10.2 Firm hold

10.3 Error messages

10.4 Needle not in starting position

10.5 Handwheel turned manually

10.6 Seing-start side not correct
The pressure monitor monitors the pressure of the air supply. If the
pressure is inadequate this warning message appears in the display.
Fault rectification
Switch the machine off.
–
Ensure that the air pressure is adequate.
–
Switch the machine on again.
–
When the machine is in firm hold mode this warning message appears
in the display.
If an error or fault occurs, a window containing an error code appears.
Error messages are described in the Servicing instructions.
If the needle is not in its upper starting position when sewing begins,
appears this message appears.
Rectification
Turn the handwheel until the message disappears.
–
If the machine is halted during operation and the handwheel turned,
this symbol appears when it is restarted.
The current sewing process must be abandoned.
If when sewing begins the needle is about to execute the right needle
insertion on subclasses 121, 141 and 151 (or the left needle insertion
on subclass -112), this warning message appears.
To clear the error turn the handwheel until the message disappears.
If the warning message appears straight after switch-on, the RST key
must be pressed when the message has disappeared.
The machine moves to the starting position.
1
35