Redundancy Screen - ZyXEL Communications 802.11 a/g User Manual

5.6 Redundancy Screen

Use this screen to set the controller AP as a primary or secondary controller.
If you set your NWA as a primary controller AP, you can have a secondary
controller AP to serve as a backup. All configurations are synchronized between
the NWA and the secondary controller AP.
When the NWA is in AP controller mode, click CONTROLLER > Redundancy. The
following screen displays.
Figure 28 The Controller > Configuration Screen
The following table describes the labels in this screen.
Table 12 The Controller > Redundancy Screen
LABEL
Redundancy
Primary AP Controller
Secondary IP
Secondary AP Controller
Apply
Reset
NWA-3500/NWA-3550 User's Guide
DESCRIPTION
Select Enable to set the NWA either as a Primary AP
Controller or as a Secondary Controller AP.
Select Disable when the NWA acts as a primary AP
controller without a backup.
Select this if the NWA has a secondary controller AP. You
must give the IP address of this backup in the field below.
Enter the IP address of the secondary controller AP.
Select this if the NWA is the secondary controller AP.
Click this to save the changes in this screen.
Click this to return the fields in this screen to their
previously-saved values.
Chapter 5 Controller AP Mode
61