ZyXEL Communications 802.11 a/g User Manual page 42

Chapter 3 Status Screens
Table 4 The Status Screen
LABEL
Registration Type
Management Mode This field is available only when the NWA is in AP controller
System Resources
Flash
Memory
CPU
WLAN1
Associations
WLAN2
Associations
Interface Status
Interface
Status
Rate
SSID Status
Interface
42
DESCRIPTION
This field is available only when the NWA is in AP controller
management mode.
This displays Manual when an access point in managed AP mode
needs to register to the NWA manually or Always Accept when
the NWA automatically adds any detected access point in
managed AP mode to the managed AP list.
management mode.
This displays Controller when the NWA is in AP controller
management mode.
This field displays the amount of the NWA's flash memory
currently in use. The flash memory is used to store firmware and
SSID profiles.
This field displays what percentage of the NWA's volatile memory
is currently in use. The higher the memory usage, the more likely
the NWA is to slow down. Some memory is required just to start
the NWA and to run the web configurator.
This field displays what percentage of the NWA's processing ability
is currently being used. The higher the CPU usage, the more likely
the NWA is to slow down.
This field is not available when the NWA is in AP controller
management mode.
This field displays the number of wireless clients currently
associated with the first wireless module. Each wireless module
supports up to 128 concurrent associations.
This field is not available when the NWA is in AP controller
management mode.
This field displays the number of wireless clients currently
associated with the second wireless module. Each wireless module
supports up to 128 concurrent associations.
This section is not available when the NWA is in AP controller
management mode.
This column displays each interface of the NWA.
This field indicates whether or not the NWA is using the interface.
For each interface, this field displays Up when the NWA is using
the interface and Down when the NWA is not using the interface.
For the LAN port this displays the port speed and duplex setting.
For the WLAN1 and WLAN2 interfaces, it displays the downstream
and upstream transmission rate or N/A if the interface is not in
use.
This section is not available when the NWA is in AP controller
management mode.
This column displays each of the NWA's wireless interfaces,
WLAN1 and WLAN2.
NWA-3500/NWA-3550 User's Guide