Clock Setting; Radio Operations - Jensen JIMS-260I User Manual

NOTE: Only use a well-known brand of cell battery to ensure the longest life and
best performance.
BATTERY CARE
i. If the unit is not used for an extended period of time, remove the battery. An old
or leaking battery can cause damage to the unit and may void the warranty.
ii. Do not dispose batteries in fire. Batteries may leak or explode.
iii. Do not try to recharge batteries that are not intended to be recharged; they can
overheat, rupture and leak (Follow battery manufacturer's directions).
iv. Only an adult should replace the battery.
NOTE:
i. The clock has to be set the first time you plug the unit in.
ii. The Clock is set to default in 12 Hour mode.
With the unit in standby mode (power OFF):
Setting 12/24 Hour format
1.) Press and hold the CLOCK ADJUST (CLK. ADJ) button until 12H or 24H
appears flashing on the display. Press the
between 12 hour (12H) or 24 hour (24H) format.
2.) Press the CLK.ADJ button to confirm, the Hour digit(s) will flash to prompt for
input.
Setting the Clock
3.) To set the hour, repeatedly press the
hour digit(s). Press and hold the buttons to speed the forward or reverse
scanning of the digits.
Make sure the hour is set so that AM or PM is displayed
NOTE:
4.) Press the
CLK.ADJ
flash to prompt for input.
5.) To set the minutes, repeatedly press the
correct minute digits. Press and hold the buttons to speed the forward or
reverse scanning of the digits.
6.) Press the
CLK.ADJ
Tuning the Radio
1.) Press the POWER ON/STANDBY
on the remote control to turn on the unit. Press the FUNCTION button
repeatedly to select the FM mode.
2.) Repeatedly press the
station.

CLOCK SETTING

button to confirm the hour setting and the minute digits
button again to complete the clock setting.

RADIO OPERATIONS

button located on top of the main unit or
or buttons to manually tune to a desired
10
or buttons
or buttons to select the correct
or buttons to select the
to switch
correctly.