Panasonic VB-9411ADSUK Operation Instructions Manual page 87

(1) Setting the Exchange line incoming call Answer Time
Sets how long after detection of ringing the unit will answer the call. This setting is set by DIP
switches SW2-2 and SW2-3 of SW2.
SW2-2 SW2-3
OFF OFF
OFF ON
ON OFF
ON ON
(2) Setting the Recording Time
The recording time setting sets the recording time of the response message. This setting is set by
DIP switch SW1-3 of SW1.
SW1-3 Recording Time
ON Max. 16 seconds
OFF Max. 32 seconds
(3) Wait for dialling timer
Sets how long the unit waits for the caller to dial after completion of OGM, before proceeding.
This setting is set by DIP switches SW2-5 and SW2-6 of SW2.
SW2-5 SW2-6
OFF OFF
OFF ON
ON OFF
ON ON
(4) Setting the Internal Line Call Mode
The internal line call mode setting sets the extension dial mode when a designated extension is
called determining either tone or voice call is used. This setting is set by DIP switch SW2-1 of
SW2.
SW2-1 Dial Method
OFF Dial "1" not appended
ON Dial "1" appended
Table 6
Exchange line incoming call Response Standby Time
8 Seconds
16 Seconds
32 Seconds
Immediate answer
Table 7
Description
When this setting is made, the recording time of the response message becomes
the maximum 16 seconds. Two messages can be recorded.
When this setting is made, the recording time of the response message becomes
the maximum 32 seconds. Only one message can be recorded.
Table 8
Exchange line Response Standby Time
2 Seconds
6 Seconds
10 Seconds
14 Seconds
Table 9
Description
When this setting is made, the reception dial from the calling side is dialed as it
is to call up the other party's extension.
When this setting is made, the reception dial from the calling side appended
with "1" is dialed to call up the other party's extension.
This setting must be set when the system is set to voice call up.
I-27
CONNECTION OF OPTIONAL UNITS
Initial setting
K
Initial setting
Initial setting
K
Initial setting
K
K