Data Terminal Programming - Panasonic VB-9411ADSUK Operation Instructions Manual

DATA TERMINAL PROGRAMMING

You can also program the system using a data terminal, which gives you the advantage of checking
the programming steps on the display screen before making final changes. At every stage in the
programming there are help screens available by pressing the "H" key on the terminal keyboard.
Entering The Data Terminal Programming Mode
To Enter On-Site Progrmming
1
ON/OFF
d
#
2
d
3 9 9
d
4 Enter programmed 4-digit ID code (Initially not stored).
IMPORTANT
Communication software must be installed to the personal computer to activate
On-Site/Remote Programming.
Call Logging I/F Card must be installed to the CCU to activate On-Site/Remote Program-
ming.
To Enter Remote programming
1
HOLD
d
# 6
2
d
3 Enter programmed 4-digit ID code (Initially not stored).
To Store and Confirm ID code
(1) To Store
1
ON/OFF
d
# 6
2
d
3 Enter 4-digit ID code.
d
4
HOLD
d
5
ON/OFF
NOTE : ID code is used for both Remote programming and On-Site programming.
(From administrator's phone)
after picking up an incoming call from Exchange line (Personal Computer).
(From administrator's phone)
P-9
BEFORE PROGRAMMING
(2) To Confirm
1
(From administrator's phone)
ON/OFF
d
# 6
2
d
3
ON/OFF