Panasonic VB-9411ADSUK Operation Instructions Manual page 127

0603#-(0,1-8)#
TRUNK TO TRUNK TIMER
Sets the time if the timer was activated using Trunk to
Trunk of call.
0#: End by call detection
1#: MAX.1 minute
2#: MAX.2 minutes
3#: MAX.3 minutes
4#: MAX.5 minutes
REFERENCE : See MODE 1 0605#.
0604#-(0, 1 or 2)#
TRUNK TO TRUNK INTERRUPT EX-
TENSION
To enable extension to interrupt a Trunk to Trunk call.
0#: No interrupt extension
1#: Function Assigned extension
2#: Administrator's telephone or Function Assigned
extension
NOTE : "Function Assigned extension" is the extension
which originally operated Trunk to Trunk
feature.
0605#-(0, 1-9)#
BUSY TONE COUNT FOR TRUNK-TO-
TRUNK END
During an exchange line call, a noise is sometimes
detected as a busy tone by mistake and disconnects an
exchange line.
To prevent this disconnection, initially CCU will watch
for 16 seconds (4sets) and decides whether its noise or
not.
0#: None
1#: 1 set
2#: 2 sets
3#: 3 sets
4#: 4 sets
NOTE : With some switchboards, there is a howler signal
or mute state following a Busy Tone of a fixed
length of time.
If this happens, the call cannot be ended by Busy
Tone detection.
5#: MAX.10 minutes
6#: MAX.20 minutes
7#: MAX.30 minutes
8#: MAX.40 minutes
5#: 5 sets
6#: 6 sets
7#: 7 sets
8#: 8 sets
9#: 9 sets
P-33
PROGRAMMING (MODE 1)
0701#-(0, 1 or 2)#
INTERNAL DTMF SENDING TIME
While the key telephone and the single-line telephone
are connected on the intercom line, you can send DTMF
signals to the single-line telephone. You can set the
transmission time and minimum pause time.
0#: 80/80 mseconds (Transmission time/
Minimum pause time)
1#: 125/125 mseconds
2#: 250/250 mseconds
REFERENCE : See MODE 1 0702# and 0703#.
0702#-(0 or 1)#
EXTEND INTERNAL DTMF SENDING
TIME (MODIFICATION)
Depending on the time set in internal DTMF Sending
Time, you can lengthen the DTMF signal.
0#: DTMF signal does not change
1#: Lengthen signal
REFERENCE : See MODE 1 0701# and 0703#.
0703#-(0, 1 or 2)#
EXTEND INTERNAL DTMF SENDING
TIMER
If the time set in DTMF Sending Time is lengthened,
you can determine how long the transmission will be.
0#: 320/320 mseconds
1#: 480/480 mseconds
2#: 695/695 mseconds
REFERENCE : See MODE 1 0701# and 0702#.
0801#-(0 or 1)#
CALL BROAKERING (SHUTTLING)-
SINGLE LINE TELEPHONE
On an SLT after an Exchange line call is put on hold an
internal call may be made, if busy tone is receieved, on
pressing Recall key program specifies whether to
receive internal dial tone or retrieve to the held Ex-
change line.
0#: Return to internal dial tone
1#: Retrieve held Exchange line