Dtmf Signal Conversion - Panasonic VB-9411ADSUK Operation Instructions Manual

PROGRAMMING (MODE 2)
(01-04)07#-(0 or 1)#
DTMF SIGNAL CONVERSION (AUTO-
MATIC)
The dial signal automatically converts to a DTMF signal
from pulse dialing. Timing of conversion will depend
on programmings listed below (REFERENCE). Press-
ing # or is not required.
However, during incoming calls the dial signal auto-
matically converts immediately without an interval.
0#: Automatic conversion disable
1#: Automatic conversion enable
REFERENCE : • See MODE 1 0302#.
• See MODE 2 (01-04)23#.
(01-04)08#-(0 or 1)#

DTMF SIGNAL CONVERSION

(MANUAL)
Press # or to convert the dial signal to a DTMF signal.
0#: Conversion disable
1#: Conversion enable
(01-04)09#-(0 or 1)#
DTMF SIGNAL TIME CHANGE (AFTER
THE OTHER PARTY'S ANSWER)
When you change from pulse dialing to a DTMF signal
after the other party's answer, the sending time of the
DTMF signal can be changed. Or DTMF signal time
will be changed if it's originally DTMF signal. Actual
signal length after the conversion is selected in Mode 2
(01-04)10#. This programming is effective for both
automatic and manual conversion.
0#: No change
1#: Changes length of the DTMF signal
sending time
REFERENCE : • See MODE 1 0302#.
• See MODE 2 (01-04)07#, (01-04)08#, (01-
04)10# and (01-04)23#.
(01-04: Exchange
c
line No.)
(01-04: Exchange c
line No.)
(01-04: Exchange
line No.)
P-38
(01-04)10#-(0, 1 or 2)#
DTMF SIGNAL TIME TABLE (AFTER
THE CONVERSION)
The settings for the DTMF signal time are shown below
(Signal length/Pause length).
0#: 320/320 mseconds
1#: 480/480 mseconds
2#: 695/695 mseconds
REFERENCE : See MODE 2 (01-04)02#, (01-04)07#, (01-
04)08# and (01-04)09#.
(01-04)11#-(0, 1-3)#
EXTERNAL RINGER CONTROL
You can control external ringer using multi purpose
relay on doorphone adaptor.
To set when (Day/Night) to ring.
0#: Does not ring
1#: Control only in Day mode
2#: Control only in Night mode
3#: Control in both Day and Night mode
REFERENCE : See MODE 1 0501#.
(01-04)12#-(0 or 1)#
INCOMING CALL FORWARDING TO
OUTSIDE
To set a received call forwarding to outside. This
function does not work if the Do-Not-Disturb and
Absence functions are activated.
0#: Cannot accept call forwarding
1#: Enable call forwarding to the exchange line
(01-04)13#-(0, 1-4)#
DELAYED RING TRANSFERRING TIME
To set the amount of a call is to remain unanswered
before the other designated phones start ringing.
0#: Disable
1#: After 15 seconds
2#: After 30 seconds
3#: After 45 seconds
4#: After 60 seconds
(01-04: Exchange c
line No.)
(01-04: Exchange c
line No.)
(01-04: Exchange c
line No.)
(01-04: Exchange
c
line No.)