Wispr Login Url; Wispr Logoff Url; Access-List - HP MSM7XX Reference Manual

wispr login url

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
wispr login url <url>
Specifies the WISPr login url assigned to the service controller.
no wispr login url
Deletes the WISPr login url assigned to the service controller.

wispr logoff url

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
wispr logoff url <url>
Specifies the WISPr logoff url assigned to the service controller.
no wispr logoff url
Deletes the WISPr logoff url assigned to the service controller.

access-list

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
access-list <index> <rule>
Adds a new rule to an access list at the specified index position.
no use access-list
Do not use an access list.
Parameters
Index position of the rule within the access list.
index
Access list rule definition in the format:
rule
<listname>[,OPTIONAL],<action>,<protocol>,<address>,<port>[,<accou
nt>[,<interval>]]
Specifies a name (up to 32 characters long) to identify the access list this
<listname>
rule applies to. If a list with this name does not exist, a new list is created.
If a list with this name exists, the rule is added to it.
Allows the access list to be activated even if this rule fails to initialize. For
OPTIONAL
example, if you specify a rule that contains an address which cannot be
resolved for some reason, the other rules that make up the access list will
still be initialized. If you do not specify optional, a failed rule will cause the
entire list to fail. Critical access list definitions (such as for a remote login
page, certificates) should not use the OPTIONAL setting because if these
definitions fail to initialize there will be no indication in the log.
Specifies what action the rule takes when it matches incoming traffic. Two
<action>
options are available:
„
ACCEPT - Allow traffic matching this rule.
„ DENY - Reject traffic matching this rule.
„
WARN - Redirect traffic matching this rule to an error page.
Specify the protocol to check: tcp, udp, icmp, all
<protocol>
Specify one of the following:
<address>
CLI commands
2-55