bandwidth control internet-port normal
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
bandwidth control internet-port normal <min-tx-%> <min-rx-%> <max-tx-%> <max
rx-%>
Sets the bandwidth rates (Tx minimum, Tx maximum, Rx minimum, and Rx maximum) for traffic
classed as Normal.
bandwidth control internet-port very-high
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
bandwidth control internet-port very-high <min-tx-%> <min-rx-%> <max-tx-%>
<max-rx-%>
Sets the bandwidth rates (Tx minimum, Tx maximum, Rx minimum, and Rx maximum) for traffic
classed as Very High.
ip route gateway
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip route gateway<destination>/<mask> <gateway> <[metric]>
Adds a static route.
no ip route gateway <destination>/<mask> <gateway> <[metric]>
Removes the specified static route.
Parameters
Traffic addressed to this IP address will be routed.
<destination>
Indicates the number of bits in the destination address that is checked for a
<mask>
match.
Indicates the IP address of the gateway the service controller will forward
<gateway>
routed traffic to. The gateway address must be on the same subnet as one
of the available interfaces (Internet port or LAN port).
Indicates the priority of a route. If two routes exist for a destination
<metrix>
address then the service controller chooses the one with the lower metric.
firewall mode
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
firewall mode (high|low|none)
Sets the firewall mode.
Parameters
Permits all outgoing traffic. Blocks all externally initiated connections.
high
Permits all incoming and outgoing traffic, except for NetBIOS traffic. Use
low
this option if you require active FTP sessions.
Disables the firewall.
none
CLI commands
2-41