Sample Cli Session; File Transfer; A. The Service Controller Gets The File Using A Url; B. Send A File To The Service Controller - HP MSM7XX Reference Manual

Introduction

Sample CLI session

Sample CLI session
This sample CLI session shows you how to set the WAN port to use a static IP address,
disable NAT, and add an alternate IP address. (The CLI prompt is shown in bold.)
CLI> enable
CLI# config
CLI(config)# interface ip wan
CLI(config-if-ip)# ip address 192.168.66.1/24
CLI(config-if-ip)# ip address mode static
CLI(config-if-ip)# no ip nat
CLI(config-if-ip)# ip address alternate 192.168.23.56
CLI(config-if-ip)# end
CLI(config)# end
CLI# quit

File transfer

In some cases you may need to transfer files (certificates or configuration) to the service
controller. Commands that have this capability typically include <uri> or <url> in their
parameter list.
Note
When you enter the commands discussed here, the files are transferred immediately.
File transfer can be performed in two ways.
A.
The service controller gets the file using a URL
Transfer a certificate file using ftp. For example:
certificate ipsec ca ftp://ftp.example.com/certificate/my-root-certificate.pem
B.
Send a file to the service controller
Using SFTP (available with OpenSSH or SSH), authenticate with the CLI credentials. Then
send the file to the service controller. For example:
sftp msm710.mycompany.com
>login: admin
>password: ****
>put my-root-certificate.pem
file transferred (1k)
>quit
In the CLI, use the local://<filename> parameter in the URL. Replace <filename> with the
filename you used to transfer using SFTP. For example:
CLI(config)# certificate ipsec ca local://my-root-certificate.pem
1-8