Advertisement
Quick Links
This Quickstart applies to both the MSM750 Access Controller (J9330A) and the MSM750 Mobility Controller (J9327A).
This Quickstart introduces the HP ProCurve Networking MSM750 Controller and shows you how to get started using it. After following all directions in this
Quickstart, see the MSM7xx Controllers Management and Configuration Guide available at: www.procurve.com/manuals.
Hardware overview
The port to the right of the Internet port is reserved for future use.
Note:
Package contents
MSM750, mounting brackets, RJ-45 to DB-9 Console port adapter.
The MSM750 ships fully assembled and ready to operate.
LAN port and Internet port
Auto-sensing 10/100/1000 Ethernet ports, each with status lights on the left and right port
edges.
MSM750 Controller Quickstart
Reset button
Press and quickly release the button to reset the MSM750. This button cannot reset the
MSM750 to factory defaults. See Resetting to factory defaults in the MSM7xx Controllers
Management and Configuration Guide.
Console port
The MSM750 console port is a standard serial port with an RJ-45 connector. To connect to a
computer, use the supplied RJ-45 to DB-9 Console port adapter and a standard (straight
through) serial cable (male-to-female) (not supplied). For pin-out details, see the MSM7xx
Controllers Management and Configuration Guide.
Advertisement
Related Manuals for HP MSM750
Summary of Contents for HP MSM750
- Page 1 This Quickstart applies to both the MSM750 Access Controller (J9330A) and the MSM750 Mobility Controller (J9327A). This Quickstart introduces the HP ProCurve Networking MSM750 Controller and shows you how to get started using it. After following all directions in this Quickstart, see the MSM7xx Controllers Management and Configuration Guide available at: www.procurve.com/manuals.
-
Page 2: Status Lights
Connect the MSM750 LAN port to the LAN port on your computer. entering the country may result in illegal operation and may cause harmful interference to Connect the MSM750 Internet port to a network with Internet access or to the PC port of other systems. - Page 3 A factory-default MSM750 is assumed. Note: Accurate time is critical for correct operation of the MSM750, as the time configured on the In a web browser, enter the address: https://192.168.1.1. MSM750 is used on all controlled APs. Configure system time settings as follows: At the security certificate prompt proceed as follows: In the management tool, select Service Controller >>...
- Page 4 ProCurve Networking devices. By using these pools, you will get better service and keep from overloading the standard ntp.org server. If the MSM750 will not be connected to the Internet, select Add to configure your own time server, or select Set date & time (manually).
-
Page 5: Working With Controlled Aps
To verify that the MSM AP has been discovered, do the following on the MSM750: This test uses your existing wired connection to the MSM750 LAN port to test the public access interface. The MSM750 Internet port must be connected to the Internet for this test to In the Network Tree, select the + symbol next to Service Controller and then select the be successful. -
Page 6: Test The Wireless Public Access Network
Log in to the public access interface as described in Test the public access interface on page 5 and confirm that you can browse the Internet. WIRELESS SECURITY: It is recommended that once the MSM750 is installed, Caution: you review the security information in the MSM7xx Controllers Management and Configuration Guide and adjust the security settings to further safeguard the wireless network from intruders.