Pppoe Mru; Pppoe Mtu; Pppoe Unnumbered; Ip Nat Outside Source Static - HP MSM7XX Reference Manual

no pppoe auto-reconnect
The service controller will not automatically attempt to reconnect if the connection is lost.

pppoe mru

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
pppoe mru <bytes>
Specifies the maximum receive unit.
Changes to this parameter should only be made according to the recommendations of your ISP.
Incorrectly setting this parameter can reduce the throughput of your Internet connection.
Parameters
Maximum size (in bytes) of a PPPoE packet when receiving. Range: 500 -
<bytes>
1500 bytes.

pppoe mtu

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
pppoe mtu <bytes>
Specifies the maximum transmit unit.
Changes to this parameter should only be made according to the recommendations of your ISP.
Incorrectly setting this parameter can reduce the throughput of your Internet connection.
Parameters
Maximum size (in bytes) of a PPPoE packet when transmitting. Range: 500
<bytes>
- 1500 bytes.

pppoe unnumbered

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
pppoe unnumbered
Enable unnumbered mode.
no pppoe unnumbered
Disable unnumbered mode.
This feature is useful when the service controller is connected to the Internet and NAT is not
being used. Instead of assigning two IP addresses to the service controller, one to the Internet port
and one to the LAN port, both ports can share a single IP address. This is especially useful when a
limited number of IP addresses are available to you.

ip nat outside source static

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip nat outside source static (tcp|udp) <visible-port> <internal-addr>
<internal-port>
Adds a static NAT mapping which routes the specified incoming traffic to the specified IP address
on the internal network.
Parameters
Selects the protocol that the mapping will operate on.
tcp | udp
The protocol port number that the incoming traffic uses.
<visible-port>
CLI commands
2-81