Furuno GP-1850WD Operator's Manual page 37

Changing waypoint name, comment,
proximity alarm radius
1. If necessary, you can change the name
(up to 6 characters), comment (up to 13
characters), L/L position and the
proximity alarm radius (explained in detail
in Chapter 8) as follows:
a)
Select the NAME, COMMENT or
PROXIMITY ALARM RADIUS field.
b)
Use the cursor pad to select character or
digit.
c)
Enter appropriate data with the
alphanumeric keys.
Note: You cannot change shape and color of
a waypoint when it has a proximity
alarm radius entered. To change
shape or color, enter all zeroes as the
proximity alarm radius.
Changing waypoint position
1. Use the cursor pad to place the cursor in
the LAT LON field.
2. Operate the cursor pad to place the
cursor on digit to change. Enter
appropriate data with the alphanumeric
keys.
3. You can switch co-ordinates with the
N<-->S/E<-->W soft key.
Entering waypoints by range and
bearing
This method is useful when you want to
enter a waypoint using range and bearing to
a target found on a radar.
1. Press the [WPT/RTE] key to open the
WAYPOINT & ROUTE menu.
2. Press the WAYPOINTS soft key to open
the WAYPOINT menu.
3. Press the WAYPOINT BY RANGE &
BEARING soft key. The plotter screen
appears.
34 12.345' N
FROM
135 12.345' E
X
DGPS 3D
Plotter display, range and bearing selected
as waypoint entry method
4. Operate the cursor pad to place the
cursor on the location desired. The range
and bearing from own ship to cursor
appear at the top of the screen.
Note: The origin point of range and
bearing can be shifted to the place
you desire. Operate the cursor pad
to select location, and then press
the soft key START POINT. "X"
appears at the cursor position.
5. Press the NEW WPT soft key to show the
waypoint window.
6. If necessary, change data as you did in
"Entering waypoints by the cursor."
7. Press the SAVE soft key to register the
waypoint.
5. WAYPOINTS
0.01nm WPT
224.1
RNG BRG
'X'
ZOOM
IN
ZOOM
OUT
NEW
WPT
START
POINT
RETURN
5-3