8. PLOTTER ALARMS
8.1
Introduction
There are five plotter-related alarms which
generate both audible and visual alarms:
Arrival alarm, Anchor Watch alarm, XTE
(Cross Track Error) alarm, Proximity alarm,
and Speed alarm.
When an alarm setting is violated the buzzer
sounds, and the speaker icon (
in red. You may silence the alarm by
pressing the [CLEAR] key. The icon remains
on the screen until the cause of the alarm is
removed or the alarm is deactivated.
8.2
The audio alarm sounds whenever an alarm
setting is violated. You can enable or disable
the audio alarm as follows:
1. Press the [ALARM] key to show the
) appears
DGPS 3D
2. Press ▲ or ▼ to select AUDIO ALARM.
3. Press the EDIT soft key to show the
4. Press ▲ or ▼ to select ON or OFF.
5. Press the ENTER soft key or the
Audio Alarm On/Off
ALARM menu.
ON
AUDIO ALARM
ON 0.100nm
ARRIVAL ALARM
ANCHOR ALARM
ON 0.050nm
ON
PROXIMITY ALARM
ON 0.100nm
XTE ALARM
OVER/UNDER
SPEED ALARM
12.5 ~ 15.0kt
ALARM INFORMATION
NO ALARM
Alarm menu
audio alarm window.
AUDIO ALARM
ON
OFF
Audio alarm window
[ENTER] key to register your selection.
ALARM
EDIT
CLEAR
ALARM
8-1