Introduction; Entering Data For Administrative Options - Avaya 4600 Series Installation Manual

Local Administrative Options
P r o g r a m

Introduction

After you have successfully installed an IP Telephone, you may be instructed to administer one of
the following options.
To set parameters for all 4600 Series IP Telephones that download their upgrade
script and application files from the same TFTP server, you can modify the upgrade
script. See the section on "Customizing the Upgrade Script File" in Chapter 4 of the
4600 Series IP Telephone LAN Administrator's Guide.
WARNING:
Perform these procedures only if instructed to do so by the system or LAN administrator.
Static administration of these options will cause upgrades to work differently than if they are
administered dynamically. The values assigned to options in static administration will not be
changed by upgrade scripts. They will remain active for the IP Telephone until a new boot file
is downloaded.
Aside from SSON, these procedures are to be used only if you are using static addressing,
and, as always, only if instructed by the system or LAN administrator. Do not use these
procedures (aside from SSON) if you are using DHCP.

Entering Data for Administrative Options

This section describes how to enter data for the administrative options.
1. All local procedures are invoked by pressing the Hold button, up to 7 numeric dial pad
buttons, and the # button.
A 6-second timeout is in effect between button presses after the Hold button is pressed; if a
valid button is not pressed within 6 seconds of the previous button, the collected digits are
discarded, and no administrative option is invoked.
2. Attempts to enter invalid data are rejected, and the phone emits an error beep.
3
3
3
3

Introduction

3-1