Qos Option Setting - Avaya 4600 Series Installation Manual

4600 Series IP Telephone Installation Guide
4. Enter the appropriate value for the port number followed by the # button.
The following message is displayed:
Router=nnn.nnn.nnn.nnn
New=_
where "nnn.nnn.nnn.nnn" is the value of the Gateway/router IP address.
5. Enter the IP address of the Gateway/router followed by the # button.
The following message is displayed:
Mask=nnn.nnn.nnn.nnn
New=_
where "nnn.nnn.nnn.nnn" is the value of the IP netmask.
6. Enter the IP netmask followed by the # button.
The following message is displayed:
FileSv=nnn.nnn.nnn.nnn
New=_
where "nnn.nnn.nnn.nnn" is the value of the TFTP server IP address.
7. Enter the IP address of the TFTP server followed by the # button.
The following message is displayed:
Save new values?
*=no #=yes
8. Press the # button to save the new values you have entered.
The following message is displayed:
New values
being saved
Once the new values are stored, the telephone is reset.
If a new boot program is downloaded from the TFTP server after you enter static addressing
information, you will need to reenter your static addressing information.

QOS Option Setting

Administering QOS options is not mandatory, but it is highly recommended.
Use the following procedure to set Quality of Service (QOS) options.
1. While the phone is on-hook and idle, press the following sequence of keys on the faceplate of
the telephone:
Hold 7 6 7 # (Hold Q O S #)
Static Addressing Installation
3-4
nnn.nnn.nnn.nnn
Router=_
or
nnn.nnn.nnn.nnn
Mask=_
or
nnn.nnn.nnn.nnn
FileSv=_
or
3