Removing The Processor - Dell Vostro 220s Service Manual

Back to Contents Page
Processor
Dell™ Vostro™ 420/220/220s Service Manual

Removing the Processor

Replacing the Processor
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
NOTICE: Do not perform the following steps unless you are familiar with hardware removal and
replacement. Performing these steps incorrectly could damage your system board. For information about
contacting Dell, see
Removing the Processor
1. Follow the procedures in
2. Remove the computer cover (see
CAUTION: Despite having a plastic shield, the heat sink assembly may be very hot during normal
operation. Be sure that it has had sufficient time to cool before you touch it.
3. Remove the processor heat sink/fan assembly from the computer (see
Assembly).
NOTE: Unless a new heat sink is required for the new processor, reuse the original heat sink/fan assembly when
you replace the processor.
4. Push the release lever down and then press it outward to release it from the retention hook that secures it.
5. Raise the processor cover, if applicable.
1 processor cover 2 processor
Contacting Dell.
Before Working on Your
Removing the Computer
Computer.
Cover).
Removing the Processor Heat Sink/Fan