Clearing Cmos Settings; Flashing The Bios From The Hard Drive - Dell Vostro 220s Service Manual

1. Follow the procedures in
2. Remove the computer cover (see
3. Locate the 3-pin password connector (PSWD) on the system board.
4. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
5. Wait for approximately five seconds to clear the password.
6. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3 to enable the password feature.
7. Follow the procedure in

Clearing CMOS Settings

CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance
1. Follow the procedures in
NOTE: The computer must be disconnected from the electrical outlet to clear the CMOS setting.
2. Remove the computer cover (see
3. Reset the current CMOS settings:
a. Locate the 3-pin CMOS jumper (CLEAR CMOS) on the system board (see
b. Remove the jumper plug from the CMOS jumper (CLEAR CMOS) pins 2 and 3.
c. Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1 and 2 and wait approximately five seconds.
d. Remove the jumper plug and replace it on the CMOS jumper (CLEAR CMOS) pins 2 and 3.
4. Follow the procedure in
5. Reboot your computer.
Your computer will emit five beeps, and then issue a CMOS checksum error.
6. Press <F1> to continue.
BIOS
The system setup program resides within the BIOS on the system board. If you install a new system board, you may need to
update (or flash) the BIOS.

Flashing the BIOS From the Hard Drive

1. Turn on the computer.
2. Locate the latest BIOS update file for your computer at support.dell.com.
3. Click Download Now to download the file.
Before Working on Your
Removing the Computer
After Working on Your Computer.
Before Working on Your
Removing the Computer
After Working on Your Computer.
Computer.
Cover).
Computer.
Cover).
System Board Components).