Ieee 1394 Device Problems - Dell Vostro 220s Service Manual

A filename cannot contain any of the following characters: \ / : * ? " < > | —
filenames.
A required .DLL file was not found —
then reinstall the program:
Windows XP:
1. Click Start® Control Panel® Add or Remove Programs® Programs and Features.
2. Select the program you want to remove.
3. Click Uninstall.
4. See the program documentation for installation instructions.
Windows Vista:
® Control Panel® Programs® Programs and Features.
1. Click Start
2. Select the program you want to remove.
3. Click Uninstall.
4. See the program documentation for installation instructions.
drive letter :\ is not accessible. The device is not ready —
and try again.
Insert bootable media —
Not enough memory or resources. Close some programs and try again —
that you want to use. In some cases, you may have to restart your computer to restore computer resources. If so, run the
program that you want to use first.
Operating system not found —

IEEE 1394 Device Problems

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that
shipped with your computer. For additional safety best practices information, see the Regulatory
Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: Your computer supports only IEEE 1394a standard.
Ensure that the cable for the IEEE 1394 device is properly inserted into the device and into the connector on the
computer
Ensure that the IEEE 1394 device is enabled in system setup —
Ensure that the IEEE 1394 device is recognized by Windows —
Windows XP:
1. Click Start and click Control Panel.
2. Under Pick a Category, click Performance and Maintenance® System® System Properties ® Hardware®
Device Manager.
Windows Vista:
1. Click Start ® Control Panel® Hardware and Sound.
2. Click Device Manager.
If your IEEE 1394 device is listed, Windows recognizes the device.
The program that you are trying to open is missing an essential file. To remove and
Insert a bootable CD or DVD.
Contact Dell (see Contacting
Do not use these characters in
The drive cannot read the disk. Insert a disk into the drive
Close all windows and open the program
Dell).
See System Setup Program for assistance.