Media Card Reader - Dell Vostro 220s Service Manual

1 screws (4)
3 power cable
6. Connect the power and data cables to the back of the drive.
NOTICE: The connectors are "keyed" for correct insertion; that is, a notch or a missing pin on one
connector fits with a tab or a filled-in hole on the other connector. Align the cable connectors correctly
before inserting them to avoid damage to the connectors.
7. Ensure that the other end of the data cable is connected to an interface connector labeled "SATA0," "SATA1," "SATA2,"
or "SATA3" on the system board (see
8. Check all cables to ensure that they are properly connected and firmly seated.
9. For the Vostro 220s, replace the chassis support bracket (see
10. Follow the procedure in
11. When you restart your computer, check the drive configuration information in the system setup program:
a. Enter the system setup program (see
b. In the Drives section of the system setup program, under Drive 0 through 3, set the drive setting to the
correct configuration.
12. See the documentation that came with the drive for instructions on installing any software required for drive operation.

Media Card Reader

CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
2 hard drive
4 data cable
System Board
After Working on Your Computer.
System Setup Program
Components).
Replacing the Chassis Support
for instructions).
Bracket).