Configuring Your Computer After Removing Or Installing A Pci Or Pci Express Card - Dell Vostro 220s Service Manual

1 PCI Express x16 card
3 securing tab
5 PCI Express x1 card
7. Align the card in the connector and press down firmly. Ensure that the card is fully seated in the connector slot.
8. Replace and tighten the screw to secure the card in the slot.
9. Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
NOTICE: Do not route card cables over or behind the cards, except for Vostro 220s, which provides a cable
clip in a chassis support bracket. Cables routed over the cards, in the absence of a cable clip, can prevent
the computer cover from closing properly or cause damage to the equipment.
10. For the Vostro 220s, replace the chassis support bracket (see
11. Follow the procedure in
12. Install any drivers required for the card as described in the documentation for the card.
13. To complete the installation procedure, see
Express Card.
Configuring Your Computer After Removing or Installing a PCI or
PCI Express Card
NOTE:
For information on installing drivers and software for your card, see the documentation that shipped with the
card.
Type of Installed
Card
Sound 1. Enter the system setup program (see
Card Program
2. Go to Integrated Peripherals, select Onboard Audio
Controller, and then change the setting to Disabled.
3. Connect the external audio devices to the sound card's
connectors.
Network 1. Enter the system setup program (see
Card Program
2. Go to Integrated Peripherals, select Onboard LAN
2 PCI Express x16 card slot
4 PCI Express x1 card slot
6 securing slot
After Working on Your
Configuring Your Computer After Removing or Installing a PCI or PCI
for instructions).
for instructions).
Replacing the Chassis Support
Computer.
System Setup
System Setup
Bracket).
Removed
1. Enter the system setup program (see
System Setup Program
2. Go to Integrated Peripherals, select
Onboard Audio Controller, and then
change the setting to Enabled.
3. Connect the external audio devices to
the computer's back panel connectors.
1. Enter the system setup program (see
System Setup Program
2. Go to Integrated Peripherals, select
for instructions).
for instructions).