Copying Onto Roll Paper (Option); Semi Synchro Cutting - Lanier LW110 Operating Instructions Manual

Copying onto Roll Paper (Option)

The paper will be fed to the copier from the Roll Feeder. You can copy onto roll
paper using the following functions:

• Semi Synchro cutting

• Preset cutting
• Variable cutting
Note
If unused roll paper is left in the copier, cut 1000mm (39.4") from the edge of
the paper before you start copying.
When you want to copy a long original, curled original, or the thin original
(less than 0.1mm) which can be easily bent down, open the guides to keep the
original away from the paper entrance.
R CAUTION:
• If during copying your original gets stuck in the copier, press the
{Emergency Stop} key.
• If you stop operation by pressing this key, remove both the origi-
nal and paper.
Semi Synchro cutting
This feature lets you cut the roll paper manually to a length that approximates
to that of the original. This saves you having to measure and enter the length of
every original.
Note
Semi Synchro Cut can handle the cut length in the range 440 ~ 3000mm, 17.3"
~ 118.0".
Copying onto Roll Paper (Option)
2
19