Changing The Roll Paper Size; Removing The Roll Paper Holder; Setting The Roll Paper Holder - Lanier LW110 Operating Instructions Manual

Maintaining Your Copier

Changing The Roll Paper Size

Change the size guides on the left and
right of the roll paper holder when
you load different sized paper rolls.
Important
Always follow the instructions be-
low when adjusting the roll paper
holder. Do not force the roll paper
holder by pulling or sliding it
strongly. This could damage the
holder.
4
Removing the Roll Paper
Holder
A
Push the paper holder inwards,
and then pull it upwards to re-
move it.
Note
The paper holder is attached
with magnet and a hook.
The paper holder is on the right
in this illustration.
52

Setting the Roll Paper Holder

A
Insert the hook on the paper hold-
er into (A A A A ), and then insert the
protrusion into (B B B B ).
Note
Make sure the protrusions are
firmly in the hole.
Lock the left side of the paper
holder until it clicks.
B
Match the paper size in the win-
dows .
Standard paper sizes that can be
used in this copier are shown be-
low.