Copying Onto Roll Paper; Synchro Cutting - Lanier LW110 Operating Instructions Manual

Copying onto Roll Paper

The paper will be fed to the copier from the Roll Feeder. You can copy onto roll
paper using the following functions:

• Synchro cutting

• Preset cutting
• Variable cutting
Note
If unused roll paper is left in the copier, cut 1000mm (39.3") from the edge of
the paper before you start copying.
When you want to copy a long original, curled original, or the thin original
(less than 0.1mm) which can be easily bent down, open the guides to keep the
original away from the paper entrance.
R CAUTION:
• If during copying your original gets stuck in the copier, press the
{Emergency Stop} key.
• If you stop operation by pressing this key, remove the original.
Synchro Cutting
This function cuts roll paper automatically according to the original length.
Note
This feature can cut length of paper in the range of 280mm to 3,000mm, 11"to
118".
Copying onto Roll Paper
2
21