Adjusting Copy Image Density - Lanier LW110 Operating Instructions Manual

Copy Settings

Adjusting Copy Image Density

To make copies darker or lighter, change the density setting. There are 14 densi-
ty levels (=7 notches 2) .
• Standard density level (Default)
• 3 darker levels
• 10 lighter levels
Set the density with the {i} and {j} keys under the density indicator.
3
Note
The indicator shows seven levels at a time. When you start from the standard
image density, the middle notch corresponds to the standard image density,
and the three right notches correspond to darker densities, and the three left
notches to lighter densities.
The brighter notch shows which level is now set. If you go lower than the left-
most notch, the Lighter Copy indicator light up. The notches on the indicator
correspond to the seven lightest levels.
If you change the copy image density while repeat copying, the next copy job
will come out with new setting.
A
Press the { { { { i
B
Each time you press the { { { { i
When the indicator reaches the left edge, it returns to the right edge and the
Lighter Copy indicator lights.
30
i } } } } or { { { { j j } } } } key to adjust copy density.
i i j j
i } } } } key, the indicator moves one step to the left.
i i