Table of Contents
Advertisement
Conference
To exit a Conference (controller only):
For a Single-line conference ...
1.
Press the ON/OFF button to ON.
2.
Press the MUTE button, then replace the handset to monitor
the conference.
For a Multi-line conference ...
1.
Press HOLD button to place outside parties on hold. The
Hold Timer starts. If one of the two parties is internal, that
party is dropped.
2.
Either ... press CONF and hang up or press ON/OFF button or
use the Soft Key's EXIT option to leave the other conference
parties still connected in an unsupervised conference.
The CONF button flashes and the timer starts. There is a
warning tone before other parties are dropped.
To re-enter a Conference:
When the controller re-enters the conference, the disconnect
timer is reset.
1.
Lift the handset to re-enter a monitored conference.
2.
To re-enter a conference placed on hold, repeat steps for
establishing a conference.
3.
To re-enter an unsupervised conference, lift the handset and
press the flashing CONF button or use the Soft Key's RE-
ENTER option. The CONF button will light steady and a
confirmation tone will sound.
To terminate a Conference, the conference initiator who is
actively in the conference must:
Replace the handset, or press the ON/OFF button to OFF.
To terminate an Unsupervised Conference:
Press the flashing CONF button or use the Soft Key's END
option while on-hook, all parties will be dropped.
STSe Station User Guide
41
August 2005
Advertisement
Table of Contents
