Removing The Hdd/Ssd Module; Completing The Task; Required Tools; Starting The Task - Fujitsu PRIMERGY RX900 S1 Maintenance Manual

Hard disk and solid state drives
6.2.4

Removing the HDD/SSD module

Ê Pull the HDD/SSD module out a few centimeters.
Ê Wait for at least 60 seconds.
I
This period is necessary for the RAID controller to recognize that an
HDD/SSD module has been removed and for the hard disk drive to
come to a stop.
Ê Pull the HDD/SSD module out completely.
6.2.5

Completing the task

Perform one of the following procedures to complete the task:
1. "Installing the dummy module" on page 88
2. "Installing the HDD/SSD module" on page 80
6.3 Removing the HDD/SSD module
Trained personnel
6.3.1

Required tools

Starting and completing the task:
– key for the rack doors (if applicable)
Removing the HDD/SSD module: tool-less
6.3.2

Starting the task

Ê Perform the following procedures:
1. "Opening the rack door" on page 40
86 Maintenance Manual
RX900 S1