Installing A Hot-Plug Power Supply Unit (Psu); Required Tools; Starting The Task; Removing A Dummy Module (If Applicable) - Fujitsu PRIMERGY RX900 S1 Maintenance Manual

Power supply
5.1 Installing a hot-plug Power Supply Unit
(PSU)
Trained personnel
5.1.1

Required tools

Starting and completing the task:
– key for the rack doors (if applicable)
Installing the power supply unit: tool-less
5.1.2

Starting the task

Ê Perform the following procedures:
1. Open the rear door of the rack, see
5.1.3

Removing a dummy module (if applicable)

I
Dummy modules protect free bays against environmental impact.
Remove the dummy module before installing an additional power supply
unit.
Figure 11: Removing a dummy module from a PSU bay
54
"Opening the rack door" on page 40
Maintenance Manual
RX900 S1