Sliding The Local Service Display Inward; Completing The Task - Fujitsu PRIMERGY RX900 S1 Maintenance Manual

Cables

15.5.16 Sliding the local service display inward

Figure 237: Sliding the local service display inward
Ê Slide the local service display inward until it clicks into place.

15.5.17 Completing the task

Ê Perform the following procedures to complete the task:
1. Install the BBU holder, see
2. Install the PCI Riser, see
3. Install all expansion cards and dummy modules in PCIe slots #8 to #17,
see "Expansion cards and BBU" on page 105
I
Make sure that you reinstall each card in the slots it was located
before the replacement.
4. Install all CPUMEMRs, see
I
Make sure that you reinstall each CPUMEMR in the slot it was
located before the replacement.
5. Install all PSUs, see
348
"Expansion cards and BBU" on page 105
"Expansion cards and BBU" on page 105
"Removing the CPUMEMR" on page 190
"Installing a power supply unit" on page 55
Maintenance Manual
RX900 S1