Table of Contents
Advertisement
Safety instructions
Installation and operation
V
CAUTION!
If the device is integrated in an installation that receives power from
an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type A connector.
The server supports a mains voltage in the range of 200 - 240 V. You
may only operate the server if its rated voltage range corresponds to
the local mains voltage.
This device has a specially approved power cable and must only be
connected to a safety socket on the rack mains socket strip.
The ON/OFF button does not disconnect the device from the mains
voltage. To completely disconnect it from the mains voltage, remove
the power plug from the safety socket.
Always connect the device and the attached peripherals to the same
power circuit. Otherwise you run the risk of losing data if, for example,
the server is still operating but the peripheral device (e.g. storage
subsystem) has failed during a power outage.
Take notice that the data cables to peripheral devices are adequately
shielded.
To the LAN wiring the requirements apply in accordance with the
standards EN 50173 and EN 50174-1/2. As minimum requirement
the use of a protected LAN line of category 5 for 10/100 MBps
Ethernet, and/or of category 5e for Gigabit Ethernet is considered.
The requirements of the specification ISO/IEC 11801 are to be
considered.
Route the cables in such a way that they do not form a potential
hazard and that they cannot be damaged. When connecting up a
device, refer to the relevant notes in this manual.
Never connect or disconnect data transmission lines during a storm
(lightning hazard).
32
Maintenance Manual
RX900 S1
Advertisement
Table of Contents
