Hot-plug components
8.1.2
Installing/removing the hot-plug power supply unit
1
1
Figure 17: Unlocking and installing the power supply unit
Ê Fold down the locking lever (1) and slide the power supply unit into the
mounting location (2) as far as it will go.
The locking lever will turn upwards and engage.
Ê Check that the locking lever is properly locked in place.
If necessary, push the lever up.
Ê Connect the power supply unit to the mains (see section
server to the mains" on page
To remove the server, follow this procedure in reverse.
RX330 S1
47).
Operating manual
Hot-plug power supply units
2
2
"Connecting the
71