Removing A Hard Disk Drive From The Hard Drive Bay - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Removing a hard disk drive from the hard drive bay

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Press the hard drive carrier release latch at the green touch point and rotate the handle outward
. Pull the drive carrier out of the hard drive bay as shown in the following figure
Figure 5-39
4. Carefully separate the upper hard drive carrier rails,
in the following figure.
Figure 5-40
Carefully separate the lower carrier rails
ENWW
Removing the drive carrier from the chassis
Removing the drive from the carrier
Predisassembly procedures on page
Removing the side access panel on page
and then tilt the drive outward
, and then remove the drive from the carrier.
Removing and installing components 107
74).
76).
.
2
as shown
2