Installing A Pcie Card - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Installing a PCIe card

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the expansion card support (see
4. Select the desired expansion card slot for the PCIe card. See
on page 147
5. Raise the rear retention clamp by lifting the metal bar or the green lever as shown in the following
figure
Figure 5-95
TIP: Grasp the slot cover between two fingers—one from the inside of the chassis, and one from
the outside.
6. Remove the PCI slot cover by pulling it up, out of the chassis
ENWW
for help in selecting a slot.
.
Removing the slot cover
Predisassembly procedures on page
Removing the side access panel on page
Removing the expansion card support on page
Removing and installing components 149
74).
76).
Choosing an expansion card slot
.
2
78).